Sensaphone WSG30 System Users manual Manuel d'utilisateur télécharger pdf (Page 11)

Chapter 2: Installation

6.750

3.5

SENSAPHONE

REMOTE MONITORING SYSTEM















MENU UP

DOWN

ENTER

WSG30

WIRELESS SENSOR GATEWAY

Figure 2: Wall-mounted WSG30 Unit

TURNING OFF THE WSG30

Once the power supply is plugged-in the WSG30 will power up. If power is subsequently removed,

the internal battery will continue to power the device. If you wish to turn off the device completely,

you must enter the Power Down command at the keypad and then unplug the power supply. See steps

below:

1) Press Menu.

2) Arrow down to Diagnostics and press Enter.

3) Arrow down to Power Down and press Enter.

4) Unplug the Power Supply, then press OK (Enter).

BATTERY REPLACEMENT

The WSG30 uses one (1) 6V 1.3AH rechargeable battery (included) for backup power in the event that

main power fails. The unit will constantly recharge the battery.

In the event you need to replace the battery, be sure to use battery part # BAT-0020 (see Appendix C:

Accessories) to ensure compatibility. To remove or replace the battery, remove the (4) screws from the

bottom cover and separate the top and bottom parts of the enclosure. Remove the battery bracket and

disconnect the read & black terminals from the battery. Replace the battery, replace the bracket, and

attach the battery terminals.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 56 57

Pas de commentaire

Sensaphone WSG30 System Users manual Manuel d'utilisateur Page 11